Water-Saving Tips for Your Bathroom

A crucial component of any household is running water. However, a recent study has shown that many people in the United States typically use more water than they need in their bathrooms. If you’re looking to save some money by making your home more efficient or trying to conserve resources, below are some helpful tips for saving water in the bathroom and reducing your environmental impact:

– Try using cold tap water on your skin instead of hot tap water. Colder temperatures can feel refreshing, making it easier to get out of the bath or shower. Additionally, they are less taxing on your skin and hair, which will help you avoid dryness.

– If you use hot water, close the bathroom door for safety reasons. There’s no need to risk staying in the bathroom longer than necessary.

– If you choose to use hot water, consider using a towel warmer. Keeping warm towels available into the night will help make your body feel more comfortable and your skin looks healthy.

– Keep the toilet lid closed when not in use to prevent clogging from dust particles and other things that can get stuck in it. This will help make the water run more efficiently and conserve resources.

– Consider using a low-flow showerhead. This type of showerhead helps regulate the amount of water that you use in the shower while still providing you with enough water to feel clean and fresh. It will also reduce your environmental impact by reducing the water used over time. The EPA notes that if every household in America used a low-flow showerhead, we could save more than 1.5 billion gallons of water daily!

– Consider installing a low-flow faucet aerator on your sinks to save even more water in your home. This will allow you to use less water while still being able to wash dishes, brush your teeth, or clean up after yourself.

– Cut down on the frequency of flushing your toilets. This will help you save water and reduce the waste produced when we flush our toilets.

– Consider installing a toilet tank diverter valve on your faucet if you have a supply line that is connected directly from a meter. This will prevent the waste from flowing into your plumbing lines, which can cause clogs and lead to other problems inside the home.

– Install dual aerators for every bathroom faucet to run at lower temperatures. For example, if one taps australia only runs at about 140 degrees, but you have two that each run at a temperature of about 175 degrees, you will waste approximately 50 percent more water.

– Consider installing a low-flow shower head for your shower. These should be available at most hardware stores or online for around $20 each. This will make it much easier to conserve water and help prevent over-irrigation while still being able to lather up and condition your skin the same way you would normally.